You probably hate that old paneling in your home, but you’ve determined it’s too expensive to replace. On the other hand, you can’t stand living with it any longer because it’s starting to depress you. If fact, you may have even considered selling the house just to get away from it.
Don’t despair, there are a number of repair tricks you can do to get rid of that ugly wall paneling. This list is just a few ideas to use to brighten up your dingy old wall paneling. Be prepared to use some elbow grease, however, it’s a lot better doing a bit work than having to look at that wall paneling for one more day.
Painting the Paneling: The main rule when painting paneling is that you can’t just slap on some paint and expect a professional look. This will only take you from ugly to tacky. Paint runs and the paneling will show through as it absorbs the paint. This could also cause yellow streaks to run in the paint.
Preparing the surface is the key to painting the paneling. Start with a good cleaner to degrease the muck check more and build-up on the paneling. Use a gloss remover once you’ve applied the degreasing solution to the paneling, but don’t apply the gloss remover over large areas. Instead, rub the area in the direction of the wood grain over smaller sections. Let it set for about half an hour, and then apply the primer. Don’t try to remove the gloss remover because it needs to stay on.
Next apply the primer over frame areas and baseboards. If the wood paneling shows through after the first coat, let it dry, and go back and apply a second coat. If you don’t, it will come through your regular paint, and all your efforts are wasted. Continue applying the gloss remover over small sections and priming until you’re finished. Let it dry over night and then add caulking in those ugly grooves of the paneling. Remove the excess using a putty knife and let it dry over night. Now you’re ready to start painting your first coat of paint. Let dry following directions and put on a second coat.
Painting Wallpaper: Some wallpaper stores should have wallpaper that can be painted. This should give an appearance of a painted wall. This is a great idea so you can choose the color you want and thus get rid of that dingy, awful looking wood paneling. You can even add other colors to give it a 3-D effect as well.
First clean the paneling with a www.colorswitchhacks.club/generator/ good degreaser and let it dry. Once dried, fill in each groove with caulk to get rid of the wall paneling ridges. Clean off the excess caulk with a putty knife. If you don’t do this, your lining and wall paper won’t have a firm surface to stick to.
Next, buy a good primer and prime all of the paneling. An extra step is needed when papering your walls by applying and sizing them. It’s sticky and allows the wall paper to stick to the paneling. Now, hang your wallpaper according to directions. You should soak the paper in water, and then hang it after a few minutes. You’re now ready to paint the wallpaper. You should follow any special instructions for painting wallpaper read here provided by the paint manufacturer.
Glazing the Paneling: You may consider adding a nice shine to your paneling by glazing it. First, clean the paneling using a degreaser. Next, add a color you like and then paint it. Let it dry overnight.
Second step is to mix a satiny top color with a glaze in the correct proportions. Read the instructions that came with your paint to get the correct mixture. It’s best to paint over small sections of the paneling, one or two sections at a time. Depending on how much shine you want,you can wipe off the excess glaze with a clean rag.